Specifications

MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide 25
Figure 3-51
Figure 3-52
11) Use the up/down arrow keys to highlight the StorSave Profile item, and then press the <Enter>
key to access an associated pop-up dialog (Figure 3-52).
12) Use the up/down arrow keys to highlight the Protection option, and then press the <Enter> key
to select this option.
13) Use the up/down/right/left arrow keys to highlight the OK item (Figure 3-53) and then press the
<Enter> key to save your changes.
Figure 3-53
Figure 3-54
14) You will be presented with a warning dialog as shown in Figure 3-54. Press the Y (yes) key to
allow the write cache to be enabled [note that this mode significantly improves performance, but it
can result in a loss of data in the event of a power failure, so MaxVision STRONGLY
recommends the use of an uninterruptible power supply (UPS) with your system.
15) At this point, you will be presented with a summary description of the RAID array you have
defined (Figure 3-55).
16) Observe that this screen shows the array (3 drives) and the remaining uncommitted drive. Use
the up/down arrow keys to highlight the uncommitted drive and press the <Enter> key to select it
(the fact this has been selected will be indicated with an asterisk '*' character).
17) Now press the 'S' key to designate this selected drive as being the hot-spare (an annotation will
appear next to the drive confirming this status).