Specifications

124 MaxPac Single/Dual/Triple-Screen 8230 Training and Maintenance Guide
Required Tools
Note: It is extremely important that you use only high-quality tools so as to avoid any slippage and
stripping of screw heads and threads.
Note: It is highly recommended that you use magnetized screwdrivers so as to prevent screws from
dropping inside the case and/or aiding in retrieving them if they do drop inside the case. (If your
screwdriver isn’t already magnetized, you can make it so by repeatedly “stroking” the blade with a
permanent magnet. Using a high quality universal screwdriver with replaceable Phillips #1 and #2 bits
is a good idea to ensure that your bits are always in excellent condition.
Most of the module replacement and upgrade procedures discussed in this chapter can be performed
using only a pair of #1 (small tip) and #2 (regular tip) Phillips screwdrivers.
For some procedures, however, needle-nose pliers will be of use, and you may have to cut cable ties
on occasion.
Also, in order to replace a display or the video distribution board you will need an appropriate Allen
key/tool.
Also, in order to remove the external video front plate assembly, you will need an appropriate Allen
key/tool.