Specifications

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
28
PATENTS PENDING
HAND CONTROL
FIG. 28-2
UP
UNFOLD
FOLD
DOWN
2. Use hand control (FIG. 28-2) to
UNFOLD Lift to vehicle floor level.
Then lower the Lift DOWN to ground
level.
3. Use hand control (FIG. 28-2) to raise
Lift UP to vehicle floor level.
4. The edge of the Inboard Rollstop
should line up with the edge of the
Base Plate as shown in FIG. 28-3.
FLOOR SWITCH ADJUSTMENT
INBOARD ROLLSTOP LINED
UP WITH BASE PLATE
FIG. 28-3
INBOARD
ROLLSTOP
NOTE: The Platform FLOOR switch adjustment screw is always on the opposite side of
the Lift from the Pump Cover.
BASE PLATE
+1/4”/-0”
STOWED LIFT
(PUMP ON LH SIDE )
FIG. 28-1
ILLUMINATED
POWER SWITCH
1. Make sure power switch (FIG. 28-1) is
turned on and illuminated. Stow the Lift
(FIG. 28-1).