Specifications

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
29
PATENTS PENDING
3. Check for small gap between the big
roller on RH Closer Arm and the RH
Lower Parallel Arm (FIG. 29-1). If
there is a small gap, continue with
step 4. If the big roller is touching the
Parallel Arm, redo the FOLD SWITCH
“BALLPARK” ADJUSTMENT in this
procedure.
CHECKING BIG ROLLER CLEARANCE
(RH SIDE OF LIFT SHOWN)
FIG. 29-1
SMALL GAP
(NOT TOUCHING)
BIG
ROLLER
RH
CLOSER ARM
RH LOWER
PARALLEL ARM
4. Use the Hand Control to fold Platform
part way as shown in FIG. 29-2.
PLATFORM FOLDING
(LH SIDE SHOWN)
FIG. 29-2
5. Use the Hand Control to unfold Plat-
form to fl oor level (FIG. 29-3).
PLATFORM AT FLOOR LEVEL
(LH SIDE SHOWN)
FIG. 29-3