Specifications

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
28
PATENTS PENDING
FOLD SWITCH FINE ADJUSTMENT
1. Make sure power switch (FIG.
28-1) is turned on and illuminated.
Raise the Platform to fl oor level
(FIG. 28-1).
PLATFORM AT FLOOR LEVEL
(LH SIDE SHOWN)
FIG. 28-1
ILLUMINATED
POWER SWITCH
NOTE: When using the Manual Pump, fi rst
make sure the notches are lined up
vertically on tip of the Manual Back-
up Handle. Then make sure Handle
is fully engaged with Manual Pump
before you start pumping with the
Handle. See the Operation Manual
for more information on operating
the Manual Pump.
USING BACKUP PUMP TO RAISE
(LH PUMP SHOWN)
FIG. 28-2
BACKUP PUMP
BACKUP PUMP
HANDLE
2. Start folding Platform with the Backup
Pump (FIG. 28-2) until Controller
reads “FOLD SW” (FIG. 28-3).
FLOOR FOLD SW
CONTROLLER READING WHEN
PLATFORM STARTS TO FOLD
FIG. 28-3
FOLD SWITCH & LOWERING SWITCH ADJUSTMENTS - Continued