Specifications

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
17
PATENTS PENDING
PLATFORM TILT ADJUSTMENT
1. Make sure power switch
(FIG. 17-1) is turned on
and illuminated. Lower the
Platform and stop approx-
imately 4” above ground.
NOTE: The platform tilt adjustment is important for operation of the Outboard Roll-
stop and for keeping Platform level when it reaches the ground. Vehicle fl oor
height, Lift installation angle, and stiffness of the Vehicle suspension may
change the angle of Platform on the ground.
PLATFORM LOWERED TO GROUND LEVEL
(RH SIDE SHOWN)
FIG. 17-1
PLATFORM
ILLUMINATED
POWER
SWITCH
GROUND
LEVEL
4”
NOTE: Do this procedure if structure of the Lift is undamaged and:
• Outboard Rollstop will not open all the way when Platform reaches the
ground.
• Bottoms of the Vertical Arms touch the ground before Outboard Rollstop.
• Platform is sloped down excessively toward the Outboard Rollstop.
The adjustment is done correctly if:
• Outboard Rollstop will open all the way when Platform reaches the ground.
• Outboard Rollstop will touch the ground before bottoms of Vertical Arms.
• Platform will slope down a little toward the Outboard Rollstop.