Service manual

Operating Manual SL6000 Series

Page 8 of 27

Attaching and removing the belt clip

To Install:

Install belt clip onto the belt clip holder located on the upper part of the battery, held with

the at the back of the unit facing upwards. Locate slot location in belt clip and push belt

clip until a click is heard.

To remove:

Push and hold release button located at top of belt clip and slide clip off the belt clip

holder.

Battery charging and care

To ensure peak performance from your radio, the battery pack must be fully charged.

Proper care and charging will allow maximum performance and life of your battery pack.

CH-SL6000-01 Desktop Charger provides 2 hour charging.

SL6000-01 charger specification

1) input voltage: DC12V Normal

2) Input voltage range: DC10.5~15V

3) Input Current 1.0A max at Full load

Programming

Please refer to the SL6000 Series Programming manual for detailed programming

information.

The programming kit required is the PR- SL6000-01

Kit consists of PK-SL6000-03 programming software

Programming lead PK-SL6000-01

To place the SL6402/6102 into program mode, connect PK-SL6000-01 programming lead

to the PC and the SL6402/6102 via 3.5mm stereo jack connector (please see top panel

layout Fig.3). To enter the radio into programming mode, press and hold the monitor

button and switch radio on. Let go of monitor when “PC Programmer” is displayed on LCD.

The radio is now in programming mode and is ready to take serial commands from the

PC.