Service manual

Operating Manual SL6000 Series

Page 21 of 27

Scan channel delete: To temporarily delete a channel from the scan list, simply press

the G/H/L button while scanning and stopped on the channel to be deleted. This will

temporarily remove that channel from the scan list until the channel is changed or the

radio's power is reset. When power is restored or the scan list channel position is again

selected, the scan list will revert to it’s original settings.

Transmitting during scanning

The radio is set to behave in a number of ways when the PTT is pressed during scan.

Normal scan TX – Radio will only transmit on a stopped channel i.e. to return a call.

Attempting to transmit during scanning will cause a warning alert.

Rx only, no TX – No transmissions are allowed during scanning. If transmission is

attempted a warning tone will be sounded.

Priority scan TX – The radio can be set to transmit on the channel on which activity has

been detected -OR- transmit on the priority channel if scanning is still active.

Priority only TX – If scanning, or listening to an active channel, and the PTT button is

pressed, the radio will only transmit on the priority channel. No transmit conditions will be

permitted. If transmission is attempted, a warning tone will be sounded.

Group scan list edit

You can edit your pre-programmed Group Scan List via the radio or by adding or deleting

channels from the group scan list.

To activate scan list editing, press the Menu button until the radio enters ‘Scan List Edit

Mode’. Upon entering ‘the Scan List Edit Mode’, the LCD will indicate the “ScnL”

message. To exit the scan list edit function, Press the PTT.

The radio displays the scan channel number by ‘S’ Icon on or off. You can change the

scan channel by using the ▼▲buttons. To add or delete this channel from the scan list,

press the monitor button. When added, the ‘S’ Icon will be displayed on the LCD display

window. When deleted, the ‘S’ Icon will disappear from the LCD.

Group priority channel edit

You can edit your pre-programmed group priority channel via the radio, by adding or

deleting channels from the group scan list.