Service manual

Operating Manual SL6000 Series

Page 10 of 27

Cloning

The SL6402 radio requires the cloning cable. The frequencies and functions can be

programmed from radio to radio by using a cloning cable.

Ensure that both radio’s power is in the switched “OFF” position.

Place the master radio (the radio which already has desired program information in the

EEPROM) in the data master mode by holding the radio’s monitor switch and then turning

radio power switch to the “ON” position (the red LED on the radio flashes). Release the

monitor switch on the third led flash (the radio will display “MASTER” message on the

LCD).

Place the slave radio (the radio which is not programmed, or has program information that

will be erased) into data slave mode by holding the radio’s monitor switch and then turning

the radio power switch to the “ON” position (the red LED on the radio flashes). Release

the monitor switch on the second led flash (the radio will display “SLAVE” message on the

LCD).

Connect the cloning cable through accessory socket.

Press the slave radio’s monitor switch. The LED will glow green.

Press the master radio’s monitor switch. The LED will glow red and cloning will start.

After cloning, the slave radio displays "COMPLETED" message and the master radio

displays “MASTER” message on LCD.

For cloning other radios, repeat above procedure.

Cloning set-up (Fig.2)

Master PK-SL6000-02 cloning lead Slave