Specifications

14
11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
ADJUSTING DRIVE CHAIN
FIG. 14-1
1. Adjust drive chains as follows.
NOTE: Vehicle body must be empty
(unloaded) before performing
the following adjustment.
ADJUST DRIVE CHAINS
2. Remove cover from Cylinder Hous-
ing. Loosen the lock nut on each chain
adjusting rod (FIG. 14-1). Then lower
Platform to ground level.
3. Turn each chain adjusting nut (FIG.
14-1) an equal amount of clockwise
turns (alternate from chain to chain) until
hydraulic cylinder is fully compressed.
Then tighten the lock nut (FIG. 14-1)
on each chain.
4. If either of the 2 chain rods are too
long, cut off the excess as shown in
FIG. 14-1.
CYLINDER
LOCK NUTS
ADJUSTING
NUTS
ADJUSTING
RODS
PERIODIC MAINTENANCE