Installation manual

6
11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
PREPARING VEHICLE BODY
This unit cannot be used with swing type doors.
Do not remove banding from shipping pallet or attempt to move the plat-
form, until:
1. The unit is welded to the vehicle.
2. The pump installation is complete and motor wiring cable instal-
lation thru vehicle battery is complete, and pump is fi lled with oil
and operating.
WARNING
!
This unit must be installed as described in this Installation Manual. If any deviation
is deemed necessary by the installer, written permission must fi rst be obtained from
MAXON.
Any change in the installation method without written permission from MAXON, will
void any warranty issued with this unit.
Please read thru this Installation Manual before commencing the installation of this
unit.
The methods of hoisting or supporting the unit during installation are those found in most
shops. If any other method of hoisting or supporting is used, precautions must be taken
to ensure the support is adequate and does not endanger the personnel working on the
installation of this unit.
Rear lights. In many cases the rear lights will need to be relocated. Relocate your rear
lights to satisfy your local codes and Federal Vehicle Safety Standard 108.
NOTE: BODIES WITH ALUMINUM CORNER POSTS.
The Aluminum corner posts must be re-inforced before install-
ing unit.
NOTE: FOR AB UNITS.
See page 36 for platform travel (chain) adjustment.