Installation manual

36
11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
ADJUSTING DRIVE CHAIN
FIG. 36-1
1. Adjust drive chains as follows.
NOTE: Vehicle body must be empty
(unloaded) before performing
the following adjustment.
ADJUST DRIVE CHAINS (ABOVE BED MODELS)
2. Remove cover from cylinder hous-
ing. Loosen the lock nut on each chain
adjusting rod (FIG. 36-1). Then lower
platform to ground level.
3. Turn each chain adjusting nut (FIG.
36-1) an equal amount of clockwise
turns (alternate from chain to chain) until
hydraulic cylinder is fully compressed.
Then tighten the lock nut (FIG. 36-1)
on each chain.
4. If either of the 2 chain rods are too
long, cut off the excess as shown in
FIG. 36-1.
CYLINDER
LOCK NUTS
ADJUSTING
NUTS
ADJUSTING
RODS