Installation manual

31
11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
CONNECT CONTROL WIRING
CONNECTING CONTROL SWITCH CABLE
TO PUMP ASSEMBLY
FIG. 31-1
1. Extend the control switch cable through hole in
pump box wall (FIG. 31-1). Connect 3 control
wires to solenoid valve and starter switch (FIG.
31-1). Ensure wiring has slack after connections
are made.
2. Connect 3 control wires to solenoid
valve and starter switch as follows
(FIG. 31-1). Crimp butt connector
on BLACK wire to open solenoid
valve wire (FIG. 31-1). Connect the
2 lugs on GREEN and WHITE wires
to correct posts on starter switch
(FIG. 31-1). Ensure wiring has slack
when connected.
BUTT
CONNECTOR
BLACK
(SOL. VALVE)
GREEN
(BATTERY+)
WHITE
(START SWITCH
COIL+)
POWER
CABLE (REF)
GROUND
CABLE (REF)