Installation manual

27
11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
Run power cable from trailer nose to tail of trailer underside (FIG.
27-1A). Route cable around pin (install loom to protect power
cable) as shown in FIG. 27-1B.
To fi x and protect power cable, install trim-lock to cross member holes
as illustrated in FIG. 27-1C.
NOTE: Loom and trim-lock is supplied in installation kit.
FRAMELESS - DRY VAN TRAILER
Never route an energized wire. Make sure the vehicle battery
is disconnected. Always route electrical wires clear of moving
parts, brake lines, sharp edges and exhaust systems. Avoid
making sharp bends in wiring. Attach securely. If drilling is
necessary, fi rst check behind the drilling surface to prevent
damage to any fuel lines, vent lines, brake lines or wires.
CAUTION
!
NOTE: Make sure cable is long enough to reach positive terminal
on Liftgate pump box without putting tension on the cable.
RUNNING POWER CABLE - Continued
RUNNING POWER CABLE ON DRY VAN TRAILER
(UNDERSIDE VIEW)
FIG. 27-1A
INSTALL LOOM TO CABLE.
ROUTE CABLE AROUND PIN.
FIG. 27-1B
INSTALL TRIM-LOCK TO CROSS MEMBER
HOLES. POSITION JOINT AT TOP
FIG. 27-1C.
PIN
POWER
CABLE
PUMP BOX
LIFTGATE