Installation manual

25
11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
RUNNING POWER CABLE
Never route an energized wire. Make sure the vehicle battery is disconnected.
Always route electrical wires clear of moving parts, brake lines, sharp edges and
exhaust systems. Avoid making sharp bends in wiring. Attach securely. If drilling
is necessary, fi rst check behind the drilling surface to prevent damage to any
fuel lines, vent lines, brake lines or wires.
CAUTION
!
FIG. 25-1
VEHICLE FRAME
18” - 24”
SPACING
CHARGE LINE TO
PUMP BOX OR
BATTERY BOX
FRONT OF VEHICLE
REAR OF VEHICLE
CHARGE LINE
TO VEHICLE
BATTERY
FRAME
CLIPS
175 AMP
FUSE
Install vehicle charge line by running the line along the inside of vehicle frame (FIG.
25-1). Make sure 175 amp fuse (FIG. 25-1) end of cable is by the battery. Run the
charge line from vehicle battery to Liftgate pump box positive terminal. Use frame clips
(parts box item) and plastic ties (as required) from charge line kit to secure cable.
NOTE: Make sure cable is long enough to reach positive terminal on Liftgate pump box
without putting tension on the cable.