Installation manual

21
11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
Cover pump box and optional battery box with fl ame-resistant covering before
welding pump box frame to vehicle.
CAUTION
To prevent pump box components from being damaged by electric current
from welding, connect welder grounding cable to the part being welded.
CAUTION
Recommended practices for welding on steel parts are contained in the cur-
rent AWS (American Welding Society) D1.1 Structural Welding Code - Steel.
Damage to Liftgate and/or vehicle, and personal injury can result from welds
that are done incorrectly.
WARNING
!
BOLTING PUMP & BATTERY
BOX FRAME
FIG. 21-1A
CROSS
MEMBERS
CROSS
MEMBERS
BRACKET
WELDING BRACKETS
(8 PLACES)
FIG. 21-1C
WELDING GALVANIZED, WARNING DECAL
FIG. 21-1B
3/16”
3/16”
3/16”
IF ACCESSIBLE
3. For galvanized frame, read
warning decal shown in FIGS.
21-1A and FIGS. 21-1B before
welding. Weld each bracket to
cross members as shown in
FIGS. 21-1A and 21-1C. Weld
top of bracket if accessible.
ATTACH OPTIONAL BATTERY BOX & FRAME TO
VEHICLE (IF EQUIPPED) - Continued