Installation manual

10
11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
WELDING LIFTGATE TO VEHICLE - Continued
2”
1/4”
WELDING PROCEDURE - STANDARD STEEL FRAME
Right hand and left hand column assemblies (FIG. 10-1) are welded to right and left hand
corner posts. Welds shall be 1/4” fi llets welds spaced as shown in FIG. 10-1 (except
where noted).
WELD COLUMN ASSEMBLIES TO VEHICLE CORNER POSTS
(LEFT HAND SHOWN)
FIG. 10-1
1/4”
BOTH SIDES OF
COLUMN, 2” LG.
(TYPICAL)
2”
ALL UNITS:
APPROX.
HALF WAY
DOWN THE
COLUMN.
1/8” WELD
When welding operations are in progress NEVER allow fl ame,
heat or sparks to come in contact with lift chain.
WARNING
!