User manual

User Manual PM200
Page 8
Front and Rear descriptions
1. Microphone socket
Connect the supplied microphone or optional DTMF/Heavy Duty microphone.
NEVER connect non-specified microphones the pin assignments may be different and
the transceiver may be damaged.
2. Volume control switch
To turn the radio ON and OFF, rotate the knob clockwise ON and anticlockwise to turn OFF.
Rotate the knob to adjust the audio output level up and down.
3. LCD Display
Displays a variety of information such as an operating channel number, SELCALL Number,
DTMF number and Volume level, etc. NOTE: The above functions depend on programming.
4. Dealer programmable keys (P1) to (P3)
Desired functions can be programmed independently by your dealer.
5. LED Indicator
Indicates radio condition from LED colour (see status and indicator and alert tones in
section 6.)
6. Emergency key
Transmits emergency call
7. Up/Down keys
Push to select the operating channel.
8. Internal Speaker
Note: Internal and external speakers can be switched by holding in the P1 and P3 buttons
during radio switch on. The display will indicate which state the radio is in.
Rear View description
9. BNC Antenna connector
Connects to an antenna. Contact your dealer about antenna selection and placement.
10. D-SUB 15Pin Connector
Connect DB-9 and DB-15 connector of
PK-PM200/250-01 to the PC and radio for
programming.
11. External Speaker Jack
Connect an 8 - 16 external speaker, if desired
12. GPS Antenna Tube
Space for a GPS antenna and internal connectors have been included for customer
applications.
13. DC Power Receptacle
Connects to a 12V Dc battery 13.8Vdc nominal 10.8Vdc minimum (extreme) 15.6Vdc
maximum (extreme).
English
Basic Radio Descriptions