User manual

User Manual PM200
Page 4
English
Safety Information
1. WARNING! NEVER connect the transceiver to an AC outlet. This may pose a fire hazard
or result in an electric shock.
2. NEVER operate the radio transmitter without a suitable artificial load or antenna
connected.
3. NEVER connect the transceiver to a power source of more than 16V DC such as a 24V
battery.
4. NEVER cut the DC power cable between the DC Plug and fuse holder. If an incorrect
connection is made after cutting, the transceiver may be damaged.
5. NEVER place the transceiver where normal operation of the vehicle may be hindered or
where it could cause bodily injury.
6. NEVER expose the transceiver to rain, snow or any liquids.
7. NEVER modify a radio or accessory except as instructed in the service manual,
engineering bulletins or formal communication as this may invalidate any warranty,
guarantee or type approval.
8. USE the supplied microphone only. Other microphones have different pin assignments
and may damage the transceiver. (ACC-700, optional DTMF MIC. ACC-703)
9. DO NOT use or place the transceiver in areas with temperatures below -30ºC or above
+60°C in areas subject to direct sunlight, such as the dashboard.
10. AVOID operating the transceiver without running the vehicle’s engine. The vehicle’s
battery will quickly run out if the transceiver transmits while the vehicle’s engine is OFF.
11. AVOID placing the transceiver in excessively dusty environments.
12. AVOID the use of chemical agents such as benzene or alcohol when cleaning, as they
damage the transceiver surfaces.
13. BE CAREFUL! The transceiver will become hot when operating continuously for long
periods.
14. DO NOT operate this equipment in environments containing explosive materials or
vapors.
Warnings