User manual

User Manual PM200
Page 16
English
Monitor Key
By pressing the Monitor button, the user shall defeat the programmed squelch operation and un-
mute the speaker on the selected channel.
Lock Key
Select the pre-programmed Function Key (P1-P3). This function can disable all keys except PTT,
Emergency Key.
Scan Key
Press the pre-programmed Function Key (P1-P3) to start and cancel the scanning operation.
(Please refer to the Scanning section)
Public address Key
User selectable On/Off. When selected and the external speaker is attached, the radio will output
voice audio over the external speaker. Please note that the PM200 will not transmit an RF carrier
in this mode.
Open/Close Key
Press to toggle the radio status Open or Close mode. When pressed to open, Selcall will be
defeated.
Selcall Key
Select the pre-programmed Function Key (P1-P3) to enter the Selcall selection mode.
Set the correct Selcall feature using , from the following options ▼▲ – ANI, RECEIVED and CALL
1-3
Basic Programmable Features
Select the pre-programmed Selcall Key (P1-P3) to transmit the selcall code or to read received
messages.
SMS Key
Select the pre-programmed Function Key (P1-P3) to enter the SMS selection mode. Set the
correct SMS text message using ▼▲
Press the pre-programmed SMS Key (P1-P3) to transmit the SMS text.
1200/2400 bps Key
Press the pre-programmed Function Key (P1-P3) to toggle between the SMS baud rate 1200 bps
and 2400 bps,
using the keys. ▼▲
DTMF Key
Select the pre-programmed Function Key (P1-P3) to enter the DTMF selection mode.
Set the correct DTMF using the Keys▼▲
Press the pre-programmed DTMF Key (P1-P3) to transmit the DTMF code.
Group Key
Select the pre-programmed Function Key (P1-P3) to enter the group selection mode.
Set the desired group using the keys.▼▲