User manual

User Manual PM200
Page 14
English
to the priority channel can be programmed between 1 to 7 seconds in 1-second increments.
When carrier, or carrier and tone, are removed, the radio will revert back to the previously
selected channel.
Transmitting During Scanning
The radio can be set to behave in a number of ways when the PTT is pressed during Scan.
Priority Scan TX – The radio can be set to transmit on the channel on which activity has been
detected -OR- transmit on the priority channel if scanning is still active.
Priority Only TX – If scanning, or listening to an active channel, and the PTT button is pressed,
the radio will only transmit on the priority channel. No other transmit conditions will be permitted.
If transmission is attempted, a warning tone will be sounded.
RX only, No TX – No transmissions allowed during scanning. If transmission is attempted a
warning tone will be sounded.
Normal Scan TX – Radio will only transmit on a stopped channel i.e. to return a call. Attempting
to transmit during scanning will cause a warning alert.
Scan Channel Delete
Pressing the “ ”▼ down key (when in scan mode and stopped on the channel) will temporarily
delete the channel from the scan list. This shall remove that channel from the scan list until the
channel is changed or the radio’s power is reset. When power is restored or the scan list channel
position is selected again, the originally programmed scan list shall be activated.
Group Scan Edit Mode
You can edit your pre-programmed Group Scan List by adding or deleting Channels from the
Group Scan List. To activate scan list editing, press and hold the P1 button on the front of the
radio and turn volume on the radio. Upon entering the scan list edit function, the LCD displays
the “Scan Edit” message. To exit the scan list edit function, turn volume off the radio.
1. Select the Scan Group
Each Scan Group would be displayed as “xx_nnn” ‘xx’ means group, and ‘nnn’ means Channel.
To activate scan list editing for selected group, press the P1 button. You can change the Scan
Group Number by using the up or down button.
2. Adding or Deleting to Scan List
If each channel is in the ‘Scan Editable List’, Channel Number would display Scan Icon, to add or
delete each channel to Scan Editable List, use P2 button.
Priority Scan Channel Edit
Scanning
Priority Channel can be setup by PC programmer. Priority Scan List is also editable by the radio. It
is called ‘Priority Channel Edit Mode’. Turn on the radio by pressing the P2 button, the radio
enters Priority Channel Edit Mode. In the Priority Edit Mode, the LCD displays the “PscanEdit”
message.