User manual

User Manual PM200
Page 10
English
Basic Radio 0peration
Before beginning operation of the product please insure installation has been carried out by a
qualified engineer. Make sure connections power, antenna and microphone have been fitted
correctly
On/Off Volume Control
Turn the radio on by rotating the off/on/volume control clockwise. You will hear a click and (if
enabled via dealer programming), the radio’s self-test alert tones. Increase the radio volume by
continuing the clockwise rotation.
To turn the radio off, rotate the control anti-clockwise until a click is heard.
Channels
The PM200/250 Series radio can store up to 208 channels within the same frequency band. These
channels can be selected by using the ▼▲ (up/down) keys. The channels can all be programmed
using the PM200/250 programmer.
Output Power
Each channel can be programmed via the PC programmer to a high-power output of 25 Watts,
and a low-power output of 2 Watts. The power can be switched by the user High / Low by
pressing pre-programmed power key (P1-P3).
Beep On/Off Mode
All Beep tones can be globally enabled or disabled via the PC programmer.
Public Address
When selected and external speaker is attached, the radio will output voice audio over the
external speaker. The radio does not TX a carrier in this mode. P/A will be shown in display when
selected. When active allows operator to enable an external speaker and transmit microphone
audio only.
Internal Speaker and External Audio Switch
The internal speaker and external accessory socket can be manually switched by the user. This
can be changed by the PC programmer. With the radio switched off hold in programmable keys
P1 and P3, Switch radio on. Display will read either External or Internal.
Microphone Hook
This is a PC programmable function. Turned OFF, the user is not required to ground microphone
button on to the Mic hanger. All decode and scan functions remain the same. Turned ON, the
user is required to ground the microphone hook. When microphone is removed from ground all
tone decode functions are disabled, scan functions are programmable as on or off with
microphone removed from hook. Default is off with scan disabled.
Basic Radio Operation