Specifications

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
23
FIG. 23-1
BOLT
WASHER
WASHER
LOCK NUT
BOLT
HINGE
BRACKET
5. Install the torsion spring as shown in FIG.
23-1. Make sure the long leg of the spring
is inserted in the spring bracket (FIG. 23-
1). Make sure the short end of the spring is
visible and resting against the hinge brack-
et (FIG. 23-1).
6. Drive the hinge pin into correct position
through the hinge bracket as shown in
FIG. 23-1. Line up the bolt hole in the
hinge pin with the hole in the shackle
and spring bracket. Bolt the hinge pin to
hinge bracket and spring bracket with
bolts, washers, lock nuts (FIG. 23-1).
Torque the 3/8”-16 spring pin bolt and
3/8”-16 spring bracket bolt 35 to 52
lbs.-ft.
7. Operate the Liftgate according to
instructions in Operation Manual
to make sure it operates correctly.
SPRING
BRACKET
SHACKLE
LONG
LEG
SHORT
CHAMFERED
LEG