Specifications

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
19
To prevent possible injury and damage
to Liftgate, have another qualifi ed person
hold platform in position to keep it from
falling open.
WARNING
!
PLATFORM TORSION SPRING ADJUSTMENT
1. Make sure vehicle is parked on level
ground. LOWER the Liftgate about 1”
above the ground (FIG. 19-1).
NOTE: Perform the following adjustment
if platform feels heavy as you start
to fold it for stowing. If adjusted
as follows, the torsion springs will
reduce the amount of effort you
need to start folding the platform.
“H”
LIFTGATE OFF THE GROUND
FIG. 19-1
90 DEGREES +2/-0
1”
CORRECTLY POSITIONED
PLATFORM & FLIPOVER
FIG. 19-2B
2. Position platform and fl ipover to 90 de-
grees, +2 / -0 degrees (FIG. 19-1). Get
a second person to hold the platform in
place while you take measurements.
3. On RH side of platform, position the
torsion spring so it rests on pin (FIGS.
19-2A & 19-2B). Make sure long leg
of torsion spring is parallel to chamfered
surface on support block (FIG. 19-2B).
Measure gap “H” between leg of the tor-
sion spring and support block (FIG. 19-
2B). Repeat for torsion spring on LH side
of platform.
TORSION
SPRING
SUPPORT
BLOCK
PIN
PIN LOCATION
FIG. 19-2A
LONG
LEG