Specifications

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
13
PERIODIC MAINTENANCE CHECKLIST
Quarterly or 1250 Cycles (whichever occurs fi rst)
Semi-annually or 2500 Cycles (whichever occurs fi rst)
Annually or 5000 Cycles (whichever occurs fi rst)
NOTE: Make sure vehicle is parked on level ground while performing maintenance checks.
Visually check the entire Liftgate for excessively worn parts and broken welds, espe-
cially hinge pins.
Visually check platform & fl ipover. (See the PERIODIC MAINTENANCE CHECKS topic
for more information.)
Visually check the thrust bearings on the shackles.
Do the Semi-annual or 2500 Cycles Checks on this checklist.
Do the Quarterly or 1250 Cycles Checks on this checklist.
Visually check the platform hinge pins for excessive wear and broken welds.
Do the Quarterly or 1250 Cycles Checks on this checklist.
Check the level and condition of the hydraulic fl uid.
Visually check all hoses and fi ttings for chafi ng and fl uid leaks, and check hydraulic lock.
Check electrical wiring for chafi ng and make sure wiring connections are tight and free
of corrosion.
For more details pertaining to this checklist, see the PERIODIC MAINTENANCE CHECKS
section in this Maintenance Manual.
Check that all WARNING and instruction decals, nonskid stickers, and safety strip-
ing are in place. Also, make sure decals are legible and decals, nonskid, and safety
striping are clean and undamaged.
Check that all roll pins are in place and protrude evenly from both sides of hinge pin col-
lar. Replace roll pins if necessary.
Check for rust and oily surfaces on Liftgate. If there is rust or oil on Liftgate or if the Lift-
gate is dirty, clean it off. Touch up the paint where bare metal is showing.
Check both platform torsion springs to make sure there is grease in the valley between
each coil. If grease is not visible, apply spray-on white lithium grease to the valley be-
tween each coil.