Owner`s manual

23
Date: 7.5.2012
Version: 1.00
P7000-K Owner’s Manual
13. Measure the voltage between the relay junction stud (the third stud from the top on the five stud junction
strip) and the white insulated ground stud. (See figure #5 – V14) It should measure battery voltage, then drop
to zero volts. When it drops to zero volts, the control module should have both LED lights illuminated. If yes,
continue to step 14. If no, check to see if the wire between the control module and the white insulated
ground stud is connected and the nut is tight. Connect and/or tighten if necessary. If connected and tight and
still no, the control module is defective and needs to be replaced.
14. Measure the voltage between the black positive insulated stud and the white insulated ground stud. (See
figure #5 – V15) It should measure 13.3 volts or higher. If yes, continue to step 15. If no, repair or replace the
white and or black wire between the nose box and the insulated studs (white and black) in the battery box.
15. Measure the voltage between the ignition junction stud (the second stud from the top on the five stud
junction strip) and the white insulated ground stud. (See figure #5 – V16) It should measure the same as
tractor battery voltage. If yes, continue to step 16. If no, the control module is defective and needs to be
replaced.
V11
V12
V13
Figure #4
V14
Figure #5
V15
V16