Specifications

Control Valves - SMARTLINK
®
MRV
www.maxoncorp.com
combustion systems for industry
Maxon reserves the right to alter specifications and data without prior notice.
© 2014 Copyright Maxon Corporation. All rights reserved.
10-30.7-89
E-i -3/14
50120624-001/
MAXON SMARTLINK
®
MRV Commands
Command Entry Requirements
Command Set ‘A’
A-0: Enter Manual Positioning Mode Unit not in Shutdown Mode
A-1: Display Alarm Codes
A-2: Enter Position Setup Mode Unit not in Shutdown Mode
A-3: Display / Change Selected Valve
A-4: Commission Valve Unit in Setup Mode, MVC input on; Shutdown Mode to replace valve
A-5: Set Max Position & Ramp Unit at Position Index = 9; not in Shutdown Mode
A-6: Set Min Position & Ramp Unit at Position Index = 0; not in Shutdown Mode
A-7: Unlock System Configuration Unit must be already “locked”
Command Set ‘B’
B-0: Select Loss of Signal Position
B-1: Set Purge Position Custom Startup enabled, MVC off, not in Shutdown Mode
B-2: Set Standby Position Custom Startup enabled, MVC off, not in Shutdown Mode
B-3: Select Deadband
B-4: Select Startup Configuration
B-5: Set Light-Off Position Custom Startup enabled, MVC off, not in Shutdown Mode
B-6: Select Auto Ramp Adjust
B-7: Select Movement Configuration
Command Set ‘C’
C-0: Valve Test Unit in Shutdown Mode
C-1: Reserved for Trained Personnel See Installation and Operating Instructions
C-2: Reserved for Trained Personnel See Installation and Operating Instructions
C-3: Reset Factory Default Settings Unit in Position Setup Mode, MVC input off
C-4: Enter New Lock Passcode Unit “unlocked” and lock function enabled to modify
C-5: Select Lock Enable / Disable Unit “unlocked” to modify
C-6: Save Profile as Backup Unit in Position Setup Mode
C-7: Restore Backup Profile Unit in Position Setup Mode, MVC input off