User manual

Toolbox 32 User Manual 1.47d www.cse-semaphore.com/mykingfisher

Page

Rx Event Logs

No longer supported. Please use the Rx Update RTU Info block.

Rx Event Logs from Specific Period

Polls event logs that occurred over a specific time period from a remote RTU. It will keep polling groups of 10

logs at a time until it has received the maximum limit of logs or until the end of the event log list is reached.

RTU: (1-249) The target RTU to poll the event logs from.

Status Register: (#R or blank) When a local register is specified, the channels are defined as follows:

• Channel 1: Pending Flag. This bit is set ON when the block is activated and then set OFF after the block

has finished.

• Channel 2: Status Flag. This bit is written after the block is finished. The status flag is set OFF if the

block was successful or set ON if the block failed (communications failure).

Start Time (minutes before now), Period: A constant (0-32767) or a local register (#R). These fields are

used to specify the time period for uploading logs.

Filter Logs by: Only event logs that match the specified priority or user type are uploaded. The maximum

number of logs to upload can also be specified.