User manual

Toolbox 32 User Manual 1.47d www.cse-semaphore.com/mykingfisher
Page
6
1. Quick Start
This chapter explains how to create and download a basic configuration for a PC-1, CP-10/11/21 or LP-
1/2/3 RTU using Toolbox 32. CP-30 / G30 RTUs are configured using Toolbox PLUS+ and ISaGRAF.
This may be a large manual but you only have to read what you need! The steps below will guide you.
1. To Install Toolbox 32 run
SETUP.EXE
(Toolbox 32 cannot be installed
on a server or run over a
network).
Latest Versions: Toolbox
upgrade files are available from
www.cse-
semaphore.com/mykingfisher
and can be used to upgrade a
full install of Toolbox.
Toolbox menu commands and
buttons to select are shown in
bold.
Note: Windows Vista and
Windows 7 do not support the
Toolbox 32 Help file. To rectify
please see Microsoft Support
Article ID 917607
http://support.microsoft.com/kb/9
17607
2. For LP-1/2/3 RTUs,
additional configuration
instructions are contained in the
LP-1 or LP-2/3 Product Manual
available from www.cse-
semaphore.com/mykingfisher.
3. Power up the RTU.
Wiring details are contained in
the power supply section of the
Hardware Manual available
from www.cse-
semaphore.com/mykingfisher.
For more information about
assembling an RTU, please see
Getting Started, Building an
RTU.
BA
-
6
12 VDC
PSU
-
3
BA
-
4
MAINS
POWER
PS11 PC-1 IO-4 AI-10 CP - 11 CP11 MC11 DI-5
MAINS
POWER
MC11
4. Connect the Toolbox cable to
port 1 of the RTU as shown.
Note: if the PC only has USB
ports (and no DB9 serial COM
ports), a USB to 9-pin [DB9
Male] RS-232 serial adapter
cable will be required.
RJ45 Cable
DB9 PC Serial Port
Adapt
e
r ADP
-
05
Port 1
To PC USB Port DB9 Male
PC-1 CP11