User manual

Toolbox 32 User Manual 1.47d www.cse-semaphore.com/mykingfisher
Page
44
Configuration - I/O Modules List
The I/O Modules list is a list of all the modules to be used in the RTU. If the I/O Modules List is configured,
Toolbox will check that it matches the modules in the local RTU before downloading the configuration. A
warning message will appear if there are any differences. The I/O modules list also allows the various
module options to be configured eg. AI-4 scanning rate, DO-2 failsafe outputs or AI-10 input range. If I/O
modules are not configured, default settings are used.
To add an I/O module to the list, the slot address of the module must be known or Toolbox can read the I/O
modules from the RTU. For a description of slot addresses, please see the appendix - RTU Data, IO
Modules.
Add: Adds a module to the list.
Delete: Deletes a module from the list.
Configure: Allows the user to configure the options of the selected module. The various options are detailed
in the next section.
Import Module List from RTU: uploads the module list from the RTU.