User manual

Toolbox 32 User Manual 1.47d www.cse-semaphore.com/mykingfisher
Page
39
Advanced Radio Configuration
A spread spectrum radio can be initialised using the Toolbox Comms Terminal. Eg. for RTU1 with an SS
radio option board on port 2, the following Comms Terminal settings would be used:
Once Comms Terminal has started, the radio may first need to be put into command mode by sending +++
<wait for a couple of seconds until OK appears>. Commands can then be sent to the radio. Command
examples:
ATRE Reset to factory defaults
ATPL2 Set Transmit power level to 100mW [default is 1W]
ATDTxxxx Sets the Destination Address to xxxx hexadecimal
ATWR Save settings to radio memory
ATID Read back the Vendor ID setting in the radio
For a comprehensive list of AT commands, a product manual (for the 9Xtend 900MHz OEM RF Module) is
available from the supplier - www.digi.com
RTU Port / Network Settings
Please see the topic Driver - Spread Spectrum Radios for port and network link settings. The topic also
describes the diagnostic data that is available from the spread spectrum radio itself.