User manual

Toolbox 32 User Manual 1.47d www.cse-semaphore.com/mykingfisher
Page
7
9. A firmware driver is downloaded using
Utilities, Advanced, Download
Firmware Driver.
Select Download to SRAM at address
offset 0 kB.
For more than one driver, ensure that
they do not overlap in memory ie. use an
address offset that is equal to (or greater
than) the size of all the drivers already in
the RTU.
When using the Paging driver, the RTU
configuration will need to be downloaded
again (step 7 above) as the paging
settings are only downloaded when the
paging driver is present in the RTU.
Note: if the LP-2/3 is cold-started, the
RTU configuration and firmware drivers
are cleared and will need to be
downloaded again.
10. LP-2/3 hardware options are set
from View, Hardware Overview.
By selecting the Slot 1 button, a number
of settings are displayed as shown.
• Ensure I/O & 5V Out is enabled
(default setting)
• Ensure V1 Out is enabled (default
setting) if using V1 Out to power I/O
or an external device
• Ensure 24V Out is enabled (default
setting) if using 24V Out to power I/O
or an external device
• Digital inputs 5 to 8 can be changed
into digital outputs 3 to 6 by selecting
the corresponding DI /DO button
• Ensure Ports 3 & 4 are enabled
(default setting) if using a comms
option board
11. To add ladder logic functionality
(including low power operation), please
see the Ladder Logic Examples chapter.
Note: if any hardware settings were
changed in the hardware overview (step
10 above), these settings should be
included in ladder logic as the LP-2/3 will
revert to the default settings after a cold-
start (please see topic - Ladder Logic
Examples, Setting Hardware Options
Using Ladder Logic).
After downloading any ladder logic, the LP-2/3 is now configured!