User manual

Toolbox 32 User Manual 1.47d www.cse-semaphore.com/mykingfisher
Page
5
2. Quick Start
An LP-2/3 is configured using Toolbox 32 software as detailed below.
1. Power up the LP-2/3 by connecting a
suitable DC supply.
The red light (LED) should start blinking
once per second if the LP-2/3 is running
correctly.
+VDC IN
GND / OV
9-15 VDC
SUPPLY
+
-
Watchdog LED: 1 second flash = RUNNING OK
2. Connect the Toolbox 32 cable* to
port 1 of the LP-2/3 as shown.
* For ADP-05 wiring details, please see
the topic Specifications, Communications
Ports.
RJ45
patch
cable
ADP-05
Port 1
[Optional] USB to DB9
Male RS232 Serial
Converter. Use if PC
does not have a DB9
serial port.
DB9 Male DB9 Female
3. After starting Toolbox 32, ensure the
correct PC communications port is being
used by the software (usually COM1).
The COM port can be changed from the
Toolbox 32 menu - Configuration, PC
Setup.
The address and baudrate of the LP-2/3
can then be detected using View, Auto
Detect.
4. Check the LP-2/3 clock is set to a
valid time and date using View, RTU
Status.
The time and date can be changed from
Utilities, Set Real-Time Clock.
Warning: the LP-2/3 will behave
unpredictably until the clock contains a
valid setting.
5. Create a new configuration by
selecting File, New.
The new configuration can be saved by
selecting File, Save As and specifying a
different name or the default name
(NEW.SDB) can be used.