User manual

Toolbox 32 User Manual 1.47d www.cse-semaphore.com/mykingfisher
Page
262
LP-1/2/3 Miscellaneous Data
Register Description Comments Read/Write
#AI2.6 Trio SR radio RSSI
(LP-1 only)
0-32760 = 0-5 V
2V = -90 dBm, 10 dB per 0.5 V steps
Read
#AI2.7 LP-1: Trio SR radio
TX power
LP-2/3: Port 3 option
board type detected
LP-1: 0-32760 = 0-5V = Vt (volts). Tx Power (W) = 1.151
x (Vt + 0.192)
2
Note: the TX power of the Trio radio must be programmed to 2
watts or less (1 watt is recommended) to prevent overloading of
the LP-1. Trio radios with higher TX power settings (eg 5 watts)
will cause a power dip in the LP-1 when transmitting - resulting
in comms failure.
LP-2/3: 0=none, 1=serial/fibre optic, 2=pstn, 3=pline,
4=Ethernet, 5=image, 6=image (running)
Read
#AI2.8 Port 4 option board
type detected
0=none, 1=serial/fibre optic, 2=pstn, 3=pline, 4=Ethernet,
5=image, 6=image (running)
Read
#AO2.13 Ports 1 and 2 Data
Format
Ch 1: Port 1 stop bits, 0=one, 1=two
Ch 2: Port 1 parity, 0=even, 1=odd
Ch 3: Port 1 parity enable, 0=disable, 1=enable
Ch 4: Port 1 data bits, 0=eight, 1=seven
Ch 5-8: Port 1 new data format enable. Must write D hex
(1101 binary) to enable.
Ch 9: Port 2 stop bits, 0=one, 1=two
Ch 10: Port 2 parity, 0=even, 1=odd
Ch 11: Port 2 parity enable, 0=disable, 1=enable
Ch 12: Port 2 data bits, 0=eight, 1=seven
Ch 13-16: Port 2 new data format enable. Must write D
hex (1101 binary) to enable.
Read/Write
#AO2.14 Ports 3 and 4 Data
Format
Ch 1: Port 3 stop bits, 0=one, 1=two
Ch 2: Port 3 parity, 0=even, 1=odd
Ch 3: Port 3 parity enable, 0=disable, 1=enable
Ch 4: Port 3 data bits, 0=eight, 1=seven
Ch 5-8: Port 3 new data format enable. Must write D hex
(1101 binary) to enable.
Ch 9: Port 4 stop bits, 0=one, 1=two
Ch 10: Port 4 parity, 0=even, 1=odd
Ch 11: Port 4 parity enable, 0=disable, 1=enable
Ch 12: Port 4 data bits, 0=eight, 1=seven
Ch 13-16: Port 4 new data format enable. Must write D
hex (1101 binary) to enable.
Read/Write
#AI3.5 Vref ADC reference voltage. 0-32767 = 0-5V
Normally 2.5V +2%
Read
#DI3.1 Firmware error 1 = Error Read
#DI3.2 SRAM error 1 = Error Read