User manual

Toolbox 32 User Manual 1.47d www.cse-semaphore.com/mykingfisher
Page
119
Example - Radios
Various types of external radios require various types of RTU ports and cables. The external radios that are
commonly used by Semaphore and the RTU setup for each radio is detailed below. Note: the spread
spectrum radio option board is detailed in the topic Driver - Spread Spectrum Radio.
Radio
RTU Option
Board
Port Type
Port
Baud
Rate
Port
Pre / Post
TX (ms)
Network
Link min.
Timeout
Trio MR450 with no modem,
Trio TC-450SR, TC-900SR,
Maxon SD-125, Tait T2010
PC-1/MC-1 Radio Radio 1200 300 / 100 2200
Line-2 Line-2 1200 300 / 100 2200
Trio MR450 with 2400 / 4800 /
9600 modem *
Any Serial board RS232
Radio
2400 /
4800 /
9600
0 / 0 2000
Trio TC-450SR with 24SR
Trio TC-900SR with 24SR
Any Serial board RS232
Radio
2400 0 / 100 2000
Trio TC-450SR with 48SR
Trio TC-900SR with 48SR
Any Serial board RS232
Radio
4800 0 / 100 2000
Trio TC-450DR
Trio TC-900DR
Any Serial board RS232
Radio
4800 /
9600
0 / 0 2000
* Trio M Series radios are configured using TVIEW+ Software. TVIEW+ allows the transmit and receive
frequencies of the radio to be set. The Packet Layer setting can also be changed to Custom (instead of
Standard). When Custom is selected, a window will appear allowing TC-23 - Action Controls – Kingfisher
to be selected (as shown below). This will configure the Trio radio to store and forward complete Kingfisher
messages.