User manual

Toolbox 32 User Manual 1.47d www.cse-semaphore.com/mykingfisher
Page
102
Ladder Logic - Image Monitoring Functions
Configure Image Parameters
Configures an image channel before it is used for the first time or when changing to a new channel. PC-
1/CP-1 requires driver IMAGExx.DRV to support an MC-xx with an Image Capture option board. Please see
the topic Example - Kingfisher Images.
Slot Address: (0-64) The slot address of the module with the image option board. Set to 0 for a CP-10/11 or
set to the slot address for an MC-10/11.
Channel Number: The image capture input channel (1-4). A port 2 image board uses channels 1 and 2. A
port 3 image board uses channels 3 and 4. The top connection on each image board corresponds to the
lower channel number.
Resolution: 0 = PAL, large (352W x 288H pixels), 1 = PAL, medium (176W x 144H pixels), 2 = PAL, small
(88W x 72H pixels), 16 = NTSC, large (320W x 240H pixels), 17 = NTSC, medium (160W x 120H pixels), 18
= NTSC, small (80W x 60H pixels). Note: setting a resolution of small is the same as setting a medium
resolution.
Quality Factor: The JPEG image quality (1-100). 1 = lowest quality (2-3 KB per image) and 100 = highest
quality (10-15 KB per image). A quality factor of at least 80 (approx. 10KB per image when resolution=0) is
recommended.
Capture Image
Captures a single image. The image is then added to a circular buffer of images. Before an image can be
captured, the image channel must first be setup using the Configure Image Parameters block (as detailed
above). PC-1/CP-1 requires driver IMAGExx.DRV to support an MC-xx with an Image Capture option board.
Slot Address: (0-64) The slot address of the module with the image option board. Set to 0 for a CP-10/11 or
set to the slot address for an MC-10/11.