Instruction manual

Model DCP-NextG Digital Cell Phone Kit
17
7.2 Software
7.2.1 SAM 3G+ Settings
Like most phone modems, the Intercel SAM3G+ has a large number of commands and
settings. These settings allow the modem to be configured in many different ways.
Modems purchased from Campbell Scientific will be pre-configured with the correct settings
to interface with our CR800,CR1000 and CR3000 data loggers. Some configuration will be
necessary for correct use with our CR200X, CR510X, CR10X and CR23X loggers.
These settings can be configured by powering the modem on and connecting the serial cable
to a PC com port. You can communicate with the modem using the Device Configuration
Utility supplied with LoggerNet.
Device Configuration Utility settings should be:
Device Type: Unknown
Baud Rate:115200
Figure 7-1 Device Configuration Utility Connection to SAM3G+