Instruction manual

Model DCP-NextG Digital Cell Phone Kit

To connect a new CS I/O modem kit to a data logger, follow these steps:

 Connect the black DCP-SAM3GPLUS-CBL’s square RJ45 connector to the socket

on the modem.

 Connect the two tinned wires on this cable to the data logger. The red wire connects

to 12V and the black wire to the G terminal. The SW12 terminal can be used instead

of 12V however since it is a switched supply it needs to be enabled in the

datalogger program to function correctly.

 Note that SW12 is a switched 12V supply and needs to be enabled in the data logger

program to function.

 Insert the 9-pin end of the DCP-SAM3GPLUS-CBL into the RS-232 (DCE)

connector on the SC932A.

 Finally, connect the male end of the SC12 cable to the logger’s CS I/O port and one

of the female ends (doesn’t matter which) to the CS I/O connector the SC932A

Ensure that the SC932A interface is connected correctly!

It is easy to connect the SC932A the wrong way around – it will not work unless the DCE

Device end is connected to the modem and the Datalogger end is connected to the logger’s

CS I/O port.

The CSIO-SAM3GPLUS-CBL cable must be used between the SC932A device and the

modem for successful communication between the data logger and the modem. The

manufacturer’s beige interface cable with the female RS-232 connector is not suitable for this

connection.