Specifications

Gas burners - INDITHERM
MAXON UNITED STATES - MAXON EUROPE - MAXON ASIA - WWW.MAXONCORP.COM
E 2.160.11
3/05
All data shown on this page are subject to change without notice.
Four lock screws ( 2) permit centering mixing cone within burner body and sleeve. They
should be drawn up hand-tight, then backed out 180° to allow for cone expansion.
They must be rechecked after start-up and loosened if necessary to prevent
deformation of cone. See start-up instruction for details.
Tightening can lead to cone distortion and greatly reduced cone and discharge
sleeve life.
Discharge sleeve (3) must be flush with, or extended beyond interior wall.
A viewing port (4) should be provided for flame observation in such a position that
burner pilot and main flame can both be seen.
Installation of flame scanner
A flame scanner can be applied to an INDITHERM burner for the purpose of flame
detection.
Installer must comply with all applicable codes and standards.
Observe required space for parts removal.