Specifications

Gas burners - INDITHERM
MAXON UNITED STATES - MAXON EUROPE - MAXON ASIA - WWW.MAXONCORP.COM
E 2.160.10
3/05
All data shown on this page are subject to change without notice.
Specific installation instructions for Maxon INDITHERM burner
systems
Instructions provided by the company responsible for the manufacture
of a complete system incorporating Maxon burners take precedence
over the installation and operating instructions provided by Maxon. If
any of the instructions provided by Maxon are in conflict with local
codes or regulations, please contact our nearest branch office or repre-
sentative.
Before reading following “installation instructions” please refer to the
“general instructions” on burner system installation, piping lay-out,
pipe size and manifolding, electrical installation and burner installation.
Burner mounting
Burner may be mounted in any position suitable for automatic control motor and
UV-scanner.
Cut opening at least 25 mm larger in diameter than discharge sleeve to allow for sleeve
expansion.(B)
Additional burner support (5) may be required in conjunction with a stiffener plate (6)
to support burner weight (50 - 175 kg). Air control motors in particular will often require
additional support.
13 mm diameter holes in discharge sleeve flange accept 10 mm stud bolts welded to
panels or stiffener.
Do not discard packing material until loose items are accounted for.
To prevent damage in transit spark ignitor discharge sleeve and linkage (if any) are
shipped “loose”.
B
1
2
3
4
5
2
space required for flame
rod/scanner removal
space required for spark
ignitor removal
oven
wall
air pressure switch
(option)
fuel supply
air supply
air supply
fuel supply
Seal welding of burner flange to stiffener plate at (A) may cause warpage of
burner flange and require additional seal material to prevent leakage.