Installation guide

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
9
STEP 2 - WELD SIDE PLATE
1. Position RH side plate with rounded corners facing up (FIG. 9-1).
CLAMPS
ANGLE STEEL
ROUNDED
CORNER
ROUNDED
CORNER
SIDE PLATE
CONDUIT BRACKET
(RH SIDE PLATE ONLY)
FIG. 9-1
2. Clamp 2 pieces of angle steel to side plate as
shown in FIG. 9-1.
NOTE: Parts box contains 2 angle steel pieces for position-
ing side plates under vehicle body. The angles allow
side plates to be positioned and clamped to bottom of
chassis crossmembers before welding the side plates.
NOTE: Angle steel pieces must be butted against the side
plate and fl ush with the edge of the side plate. Each
angle must be positioned to butt against a chassis
crossmember under the vehicle.