Installation guide

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
5
VEHICLE REQUIREMENTS
Check for correct clearances (FIGS. 5-1, 6-1 & 6-2) on vehicle to
prevent interference between vehicle and Liftgate.
VEHICLE WITH 3” CROSSMEMBERS
FIG. 5-1
53” MAX. BED HEIGHT
46” MIN. BED HEIGHT
NOTE: Make sure vehicle is parked on level ground while preparing vehicle and
installing Liftgate.
NOTE: BODY maximum and minimum operating bed height:
Maximum height is 53” (Unloaded). Minimum height is 46” (Loaded).
On vehicle bodies equipped with swing-open doors, the platform
may have to be modifi ed to install this Liftgate.
NOTE: Dimensions are provided as reference for fi tting Liftgate to vehicle body.
For detailed ground clearance information, refer to the WELD SIDE PLATE
procedure in this manual.
3”
64-1/8”- 65-3/8”
12-1/8” TO 17-5/8”
CAUTION
The sliding axel assembly on a trailer can collide with a Liftgate mounted
on the slide rails. To prevent damage to Liftgate and trailer, install stops on
the slide rails to keep the sliding axels from hitting Liftgate. Refer to Liftgate
clearance dimensions in this section of the manual.