Installation guide

11921 Slauson Ave. Santa Fe Springs, CA. 90670 [phone] FAX [phone]
21
1. Reconnect conduit to right side plate
as shown in FIG. 21-1.
STEP 5 - WELD ON EXTERNAL CONTROL & BRACKET
SIDE
PLATE
RECONNECTING CONDUIT
TO RH SIDE PLATE
FIG. 21-1
CONDUIT
2 WELDS MIN,
MORE IF POSSIBLE
3/16”
2. Weld the control box bracket
to vehicle crossmembers
on the RH side (curbside)
near rear sill of vehicle (FIG.
21-2).
Prevent damage to control box. Make sure installed control box does not
protrude from the vehicle body.
CAUTION
CAUTION
To protect the original paint system,
a 3” wide area of paint must be re-
moved from bracket on all sides of
the weld area before welding.
WELDING BRACKET TO CROSSMEMBERS
FIG. 21-2
CONTROL BOX
BRACKET
CROSSMEMBER
REAR SILL
1”- 2”