Datasheet

Setup
Jumpers
maxon motor control
3-30 Document ID: rel5869 ESCON Servo Controller
Edition: November 2015 ESCON 36/2 DC Hardware Reference
© 2015 maxon motor. Subject to change without prior notice.
3.5 Jumpers
STOP
Check on safety precautions before continuing (  page 1-5).
J
UMPER JP1
For maxon DC motor with integrated Motor/Encoder Ribbon Cable, activate the motor terminal by set-
ting both jumpers to CLOSED (Figure 3-22, right).
Figure 3-20 Jumper JP1
Figure 3-21 Jumper JP1 – Location
Figure 3-22 Jumper JP1 – OPEN, Default Setting (left) / CLOSED (right)
3.6 Potentiometers
POTENTIOMETER P1
Figure 3-23 Potentiometer P1 – Location & Adjustment Range
Adjustment angle 210°
Type Linear