User's Manual

7
NOTE: All audible tones can be programmed off for silent operation.
Status Decription LED color LCD Indication Audible Tone
Normal Power On - Ready N/A Maxon Logo Melody
Call Received Orange Channel number N/A
Correct Call Green Channel number N/A
Busy Channel Orange Channel number N/A
Transmit Red Channel number N/A
Transmit not
allowed
Red
Flashing
AlternatingUL/Channel
number
Twobeeps
repeated
Scanning Normal Scan mode Green
Flashing
Group number or channel
number (remove)
N/A
Priority Scan Mode Green
Flashing
Group number or channel
number (remove)
PriorityLook
BackScan Mode
Green
Flashing
PS/Channel number N/A
Scan
Edit
Edit scan list Red single
Flash
Scnl N/A
Priority
Edit
EditPriority
channel
Red two
Flashes
Pscn N/A
Warning Low Battery Red
Flashing
Low-BATT 3 beeps repeated
BusyChannel
lockout
orange Busy-Lock Singlebeep
repeated
TX penalty N/A TX-P Two beeps
Time-out-timer N/A TIME-OUT Singlebeep/3
beeps repeated
Scan Delete N/A Delete Single Beep
Scan All Delete N/A All-DEL Two Beep
PC-Program(Read) N/A READING
PC-rogram(Write) N/A WRITING
Clone Master N/A MASTER
Clone Slave N/A SLAVE
Unlock N/A UNLOCK Twobeeps
repeated
Scan Modes
Scanning is a Dealer programmable feature that allows you to monitor a number of channels or channels
within a Group. Your Dealer will help you define a scanning mode and your channel "scan list" .
Normal Channel Scan
Once the scan list has been established you can initiate scan by press and release of scan button, first button
located beneath the PTT button. The top panel LED can be programmed to flash green as the radio is
scanning.
If a conversation is detected on any of the channels in the scan list, the radio will stop on that channel and
you will be able tohear the conversation. If programmed for normal scan TX you will be able to transmit on
that active channel during the pro-grammable scan delay time. The scan delay time is the amount of time the
radio will stay on that channel once activity has ceased (Dealer programmable, 4-7 seconds is typical). The
radio will resume scanning once the scan delay time has expired. Scanning will continue until the channel is
changed.
Priority Channel Scan
A single channel may be programmed as the "Priority" channel. The radio will constantly monitor this
channel while scanning and when the radio has stopped on an active channel. If a call is detected on the
"Priority" channel, the radio will automatically move to, and remain on, the "Priority" channel for as long
as the priority conversation takes place. "Priority" channel activity takes precedence over all other
conversations. To activate Priority scan press and release the scan button, first button beneath the PTT
button. When priority scan has been activated display will show PS to indicate priority scan has been
activated. ( Remove)