User Manual

4
Description of Radio Components
1) Antenna Receptacle
2) Channel Selector Buttons
3) On/Off - Volume Control
4) Busy/TX/BT Indicator
5) Battery Latch
6) Push-To-Talk (PTT)
7) Monitor Button
8) Scan Button
9) Speaker
10) Microphone
11) Accessory Connector
12) Belt Clip
13) Battery
14) Battery Charge Contacts
15) LCD
Antenna Installation
Fasten the antenna to the radio by turning the antenna clockwise into the receptacle on top of the radio.
Installing and Removing the Battery Pack
To Install:
Position the guides of the battery in line with the radio battery guide rails and slide the battery into position until a click is heard.
To Remove:
Holding radio in one hand, push and hold battery latch button located in the upper right hand corner of the battery pack , held as if
looking at the back of the unit. Hold radio firmly and slide battery in downward direction while pushing the battery latch button.
Attaching and Removing the Belt Clip
To Install:
Install belt clip onto the belt clip holder located on the upper left hand corner of the radio, held as if looking at the back of the unit.
Locate slot location in belt clip and push belt clip until a click is heard.
To Remove:
Push and hold release button located at top of belt clip and slide clip off the belt clip holder.