SP-0402 Synthesized Scanning Radio MAXON CIC 1
FCC RF EXPOSURE COMPLIANCE REQUIREMENTS FOR OCCUPATIONAL USE ONLY The Federal Communications Commission (FCC), with its action in General Docket 93-62, November 7, 1997, has adopted a safety standard for human exposure to Radio Frequency (RF) electromagnetic energy emitted by FCC regulated equipment. Proper operation of this radio will result in user exposure far below the Occupational Safety and Health Act (OSHA) and Federal Communications Commission limits.
Operating Instructions About Your SP-0402 Radio Maxon's SP-0402 radio feature up to 16 channels. Operation and functions for Maxon's SP-510 radios are described in this manual. We urge you to thoroughly read this manual before operating the radio. Application of some of the functions described in this manual is determined by the system you use. Your Maxon Dealer will program your radio so that you have the greatest number of functions possible relative to your needs.
SP-0402 Features · · · · · · · · · · Wideband frequency separation 1 or 5 W programmable output power Programmable 12.
Install belt clip onto the belt clip holder located on the upper left hand corner of the radio, held as if looking at the back of the unit. Locate slot location in belt clip and push belt clip until a click is heard. To Remove: Push and hold release button located at top of belt clip and slide clip off the belt clip holder. Battery Charging and Care To ensure peak performance from your radio, the battery pack must be fully charged.
Operation Mode This section provides general descriptions of the operating modes of the SP-0402 Radio. Power Off Mode The SP-0402 shall enter Off mode when the On/Off Volume knob is rotated to the most counterclockwise position, beyond the detent. Upon entering Off mode, the radio shall store its current channel (if Power On Channel function is disabled via PC programmer). Power On Mode The SP-0402 shall enter Power-On mode when the On/Off Volume knob is rotated clockwise beyond the detent.
Short pressing: scan operaiting Look Back channel edit Tx power H/L (EMG) Transmit EMG ID 5 times and generate warning audio alert during 7secs 7
Licensing and Service Information FCC Licensing The Federal Communications Commission requires that the operator of this radio be properly licensed under the applicable Part and/or Parts of the FCC Rules and Regulations. Consult with your Maxon Dealer, or contact the nearest FCC Field Office for information about obtaining a license. Service Do not tamper with internal adjustments. Damage to the equipment and/or improper operation may result. There are no user serviceable items inside the radio.
Clean external surfaces with a clean cloth dampened in a solution of dishwasher detergent diluted in water. Apply the solution sparingly to avoid any moisture leaking into cracks and crevices. Do not submerge the radio. Use a non-metallic brush to dislodge stubborn particles, if necessary. Dry the surface thoroughly with a soft, lint free cloth. DO NOT use solvents or spirits for cleaning - they may permanently damage the housing.
