User's Manual

from the list beginning with the oldest call. Pressing the mode button a second time will
remove any unanswered calls and exit the call missed list.
NOTE: Scanning will be disabled when your call list is being accessed.
Display Brightness
Display Brightness mode, allows you to change the brightness of the display. To change
the display brightness press and release the MODE button until the word BRIGHT is
shown in the display. Press and release the up or down buttons to change the display
brightness. There are 4 levels of brightness, continuously pressing up or down buttons will
go back through your display brightness levels. Once selected the radio will return to the
previously selected System or Group.
OPT (Option) -This button will allow you to enable or disable a selected optional function. A press
and release, unless specified otherwise, will enable or disable the currently selected function
Monitor (MONITOR), Auxiliary (AUXILIARY), Public Address (P/A), no option (NONE). A press and
release followed immediately by a press and hold will allow selection of option functions using the
up or down arrow buttons. Once option is shown in display a second key press of OPT will select
option to be used under the OPT button indicated by the SCAN icon. If no button press is detected
option will not be enabled and radio will resume previous operation. All option indications will be
displayed by either an icon or in the LCD.

Scan Button - This button will allow selection between Scan and Priority scan modes. A press and
release will enable normal scanning functions a press and hold will enable Priority Scan functions. A
press and release will disable the selected Scan function. All indications will be displayed as icons,
if normal scan is selected the SCAN icon will be shown. If priority scan has been selected both the
SCAN and P icons will be shown.
Option Button Function Descriptions
Monitor
Monitor mode is only available for Conventional operation, if previously selected as the OPT
button function, allows you to open the radios squelch to listen for activity before attempting
transmission on a conventional Systems channel Group. Monitor also defeats CTCSS and
CDDCS squelch functions. Monitor can be activated by a press and release of the OPT button
opening the radios squelch. A second press and release of OPT button will close the radios
squelch. When monitor is active the word MONITOR will show in the display.