Owner's Manual

© Copyright 2017. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
Installation & Operation (Continued)
Operating Instructions WP-ADS & WP-ADL Series
MaxLite LED Large & Small Adjustable Wall Packs
®
3. Complete the assembly:
Tighten the inner side screws, close the housing and tighten the outer
side screws.
Note: This fixture is wet location rated. In order to ensure that moisture
does not enter the outlet box and cause a short circuit, clear caulking
should be used to seal the space between the fixture mounting bracket
and the wall. Ensure that a space is left at the bottom to allow for the
escape of moisture. It is recommended that outdoor silicone sealant be
used for that purpose.
4. Restore the electricity and check the operation of your new fixture:
Page: 3
REV: 4/18/17