Owner's Manual

General Wiring Diagram
Installation & Operation
Disconnect the power by turning off the circuit breaker or by removing the appropriate fuse at the
fuse box. Turning the power off using the light switch is not sufficient to prevent electrical shock.
1. Prepare fixture: If there is an existing fixture remove it. Loosen
both outer side screws and open the housing. Now loosen both
inner side screws.
© Copyright 2017. MaxLite, Inc. All Rights Reserved.
12 York Ave, West Caldwell, NJ 07006 Tel: [phone] Fax: [phone] Email: [e-mail]
CAUTION: Turn off electrical power at fuse
or circuit breaker box before wiring fixture to
the power supply.
2. Mount the mounting box and make wiring connections:
Expose the supply wires from the J-box. Mount the mounting
box to the J-box with the supplied screws. Gently pull the supply
wires through the hole in the back housing. Connect the black supply
wire to the black/brown fixture wire. Secure with the supplied wire nuts.
Connect the white supply wires to the white/blue fixture wire. Secure
with the supplied wire nuts. Connect the green wire to the supply ground
wire. Secure with wire nuts. Secure all wires with electrical tape
(not supplied). Tuck all wires carefully into the mounting box.
Page: 2
REV: 4/18/17
Operating Instructions WP-ADS & WP-ADL Series
MaxLite LED Large & Small Adjustable Wall Packs
®